SL/SST variations and their Correlations in the North East Asian

advertisement
International Conference on SMA 2012
1
Information for Title and Authors:
International Conference on Smart Media and
Applications
Gil-Dong Hong, Second B. Author and Third C. Author, Member, KISM
Abstract— Abstract should be placed here. These
instructions give you guidelines for preparing papers for
SMA. Use this document as a template if you are using
Microsoft Word 6.0 or later.
A. Figures
All tables and figures will be processed as images.
However, ICSMA cannot extract the tables and
figures embedded in your document.
Index Terms— About four key words or phrases in
alphabetical order, separated by commas such as
Maritime, Information, Communication, Science etc.
I. INTRODUCTION
THIS document is a template for Microsoft Word
versions 6.0 or later. If you are reading a paper version of
this document, please download the electronic file,
SMA2012 template paper_form_SMA2012.DOC,
from http://kism.or.kr/SMA2012/ so you can use it to
prepare your manuscript [1].
The pull-down style menu is at the left of the
Formatting Toolbar at the top of your Word window (for
example, the style at this point in the document is
“Text”). Highlight a section that you want to designate
with a certain style, then select the appropriate name on
the style menu [2],[3]. The style will adjust your fonts and
line spacing. Do not change the font sizes or line
spacing to squeeze more text into a limited number of
pages. Use italics for emphasis; do not underline [4]-[7].
II. PAPER SIZE AND FORMMAT
Each paper size should be IEEE journal size
(20.3cm x 27.5cm) and the following margins should
be set.
Top margin
Bottom margin
Left margin
Right margin
Heading
2.5cm
1.5cm
1.5cm
1.5cm
1cm
__________
Fig. 1. Magnetization as a function of applied field.
B. Math and Equation
1) Math
If you are using Word, use either the Microsoft
Equation Editor or the MathType add-on (http://www.
mathtype.com) for equations in your paper (Insert |
Object | Create New | Microsoft Equation or MathType
Equation). “Float over text” should not be selected.
2) Equation

r2
0
F (r ,  ) dr d  [ r2 / (2 0 )]


0
(1)
exp ( | z j  zi | )  J1 ( r2 ) J 0 ( ri ) d .
1
C. Table
TABLE I
UNITS FOR MAGNETIC PROPERTIES
Sym
bol
Quantity
Conversion from Gaussian
and CGS EMU to SI a

magnetic flux
1 Mx  108 Wb = 108
V·s
B
magnetic flux
density,
magnetic
induction
1 G  104 T = 104 Wb/m2
H
magnetic
1 Oe  103/(4) A/m
Gil-Dong Hong is with the Department of Communication, Hangook
University, Seoul, 123-123, Korea (Email: gdh@hangook.ac.kr)
International Conference on SMA 2012
2
field strength
1 erg/G = 1 emu
 103 A·m2 = 103 J/T
1 erg/(G·cm3) = 1 emu/cm3
 103 A/m
m
magnetic moment
M
magnetization
4M
magnetization
1 G  103/(4) A/m

specific
magnetization
1 erg/(G·g) = 1 emu/g  1
A·m2/kg
(or their employer, if it holds the copy right) ar e
authorizing the transfer of the copyright to the ICSMA,
when the paper is published.
IV. CONCLUSIONS
A conclusion section is not required. Although a
conclusion may review the main points of the paper, do
not replicate the abstract as the conclusion. A conclusion
might elaborate on the importance of the work or suggest
applications and extensions.
III. UNITS
Use either SI (MKS) or CGS as primary units. (SI units
are strongly encouraged.) English units may be used as
secondary units (in parentheses). This applies to papers in
data storage. For example, write “15 Gb/cm2 (100
Gb/in2).” An exception is when English units are used as
identifiers in trade, such as “3½ in disk drive.” Avoid
combining SI and CGS units, such as current in amperes
and magnetic field in oersteds. This often leads to
confusion because equations do not balance
dimensionally. If you must use mixed units, clearly state
the units for each quantity in an equation.
The SI unit for magnetic field strength H is A/m.
However, if you wish to use units of T, either refer to
magnetic flux density B or magnetic field strength
symbolized as µ0H. Use the center dot to separate
compound units, e.g., “A·m2.”
ACKNOWLEDGMENT
This work was supported in part by the Korea Science
and Engineering Foundation(KOSEF) grant funded by the
Korea government(MEST) (No. 2009-0083985)
REFERENCES
[1]
[2]
[3]
[4]
IV. OTHERS
A. Final Stage
When you submit your final version, after your paper
has been accepted, print it in two-column format,
including figures and tables.
You must also upload your final manuscript on our
institute Home page, which ICSMA will use to prepare
your paper for publication. Also send a sheet of paper
with complete contact information for all authors. Include
full mailing addresses, telephone numbers, fax numbers,
and e-mail addresses. This information will be used to
send each author a complimentary copy of the journal in
which the paper appears.
B. Page Charge and Reprint
Each paper will be charged according to the number of
pages. 20 prints will be supplied without additional charge
if requested. Additional reprints are available with actual
cost.
C. Copyright
Submission of manuscript is a representation that the
manuscript has not been published previously and is not
currently under consideration for publication elsewhere.
The submission is also a representation that the authors
[5]
[6]
[7]
[8]
[9]
H. Moustafa and Y. Zhang, Vehicular Networks: Techniques,
Standards, and Applications. CRC Press, pp. 109–220, 2009.
J. Zhao and G. Cao, “VADD: Vehicle-assisted data delivery in
vehicular ad hoc networks,” IEEE Trans. Vehicular Technology,
vol. 57, no. 3, pp. 1910–1922, May 2008.
H. Liu, B. Zhang, H. Mouftah, X. Shen, and J. Ma, “Opportunistic
routing for wireless ad hoc and sensor networks: present and future
directions,” IEEE Communications Magazine, vol. 47, no. 12, pp.
103–109, Dec. 2009.
J. Blum, A. Eskandarian, and L. Hoffman, “Challenges of
intervehicle ad hoc networks,” IEEE Trans. Intelligent
Transportation Systems, vol. 5, no. 4, pp. 347–351, Dec. 2004.
Z. Mo, H. Zhu, K. Makki, and N. Pissinou, “MURU: A multi-hop
routing protocol for urban vehicular ad hoc networks,” Proc. 3rd
Annual International Conference on Mobile and Ubiquitous
Systems, July 2006.
X. Yang, J. Liu, F. Zhao, and N. Vaidya, “A vehicle-to-vehicle
communication protocol for cooperative collision warning,” Proc.
International Conference on Mobile and Ubiquitous Systems, pp.
114-123, Aug. 2004.
G. Korkmaz, E. Ekici, F. Ozguner, and U. Ozguner, “Urban multihop broadcast protocol for inter-vehicle communication system,”
Proc. VANET, pp. 76-85, July 2006.
W. Zhao, M. Ammar, and E. Zegura, “New directions: A message
ferrying approach for data delivery in sparse mobile ad hoc
networks,” Proc. ACM Mobihoc, pp. 187-198, 2004.
Q. Li, and D. Rus, “Sending message to mobile users in
disconnected ad-hoc wireless networks ,” Proc. ACM Mobicom, pp.
44-55, 2000.
Download