TECH TIP
Strain Relief when using
a DXE-CC4-CON connector
A customer question came in asking if there was a way to provide strain relief when using the
DXE-CC4-CON connector. The customer was concerned since the connector was being taken
on and off multiple times and the wires were breaking.
Thanks to DX Engineering team member Bob, W5OV for describing this method that works
great.
Install the wires into the connector. Use a ZIP Tie (or Wire Tie) and snug it down tight against
the connector, holding the wires in place. There is a lip in this type of connector that makes
using a Zip Tie really easy.
Making a loop in the cable will increase the strain relief. In cases where the jacket of the cable is
too stiff to make a loop. You can use longer wires to allow making a loop and hold it in place
using a Zip Tie.
DX Engineering - 1200 Southeast Ave. - Tallmadge, OH 44278 USA
Phone: (800) 777-0703 ∙ Tech Support and International: (330) 572-3200
Fax: (330) 572-3279 ∙ E-mail: DXEngineering@DXEngineering.com
TechTip - StrainRelief - 23 Oct 2019
0
