Uploaded by rahul199019901990

TAP130-0-Capacitors-and-springs

advertisement
Episode 130: R-C circuits and other systems
There are many examples of exponential changes, both in physics and elsewhere. Your
specification may require that you make a detailed comparison of the energy stored by a
capacitor and a spring and of exponential decay in radioactivity and capacitors.
Summary
Discussion: Energy stored. (20 minutes)
Discussion: Exponential decrease. (20 minutes)
Student questions: Exponential decrease. (30 minutes)
Discussion:
Energy stored
Comparing the energy stored by capacitors and springs: The key point in the discussion is that
the graphs of ‘charge against pd’ for a capacitor and ‘force against extension’ for a spring are
both straight lines through the origin. For capacitors, the energy stored is the area under the
charge/pd graph (Episode 128). A similar argument can be used to show that the energy stored in
a spring is the area under the force/extension graph.
It follows that there are similar equations:
Energy stored in a capacitor = 1/2 QV = 1/2 CV2
Energy stored in a spring
= 1/2 Fx = 1/2 kx2
Although it is not specifically mentioned in the specifications, the energy can be released steadily
but there are many occasions where oscillations occur. Students are likely to have seen this for a
spring but may not have seen any electrical circuits involving oscillations. The section could be
concluded with a demonstration of this.
TAP 130-1: Electrical oscillations
Discussion:
Exponential decrease
Comparing exponential decay for radioactivity and capacitors: You could build up the table shown
below using contributions from members of the class.
Any such comparison needs to highlight the similarities in the patterns for two very different
physical processes by comparing the graphs of the decays. (This is a good point to remind pupils
that testing for exponentials, either by a ‘constant ratio property’ or from a log graph, is an
important skill.)
1
Capacitors
Radioactivity
Basic Equation
Q = Qo e-t/RC
N = No e-t
Rate of Decay
current I = dQ/dt = –Q/RC
activity A = dN/dt = –N
Characteristic ‘time’
Time constant = RC = time
for charge to fall by 1/e
Half life = T1/2 = time for no.
of atoms to fall by 1/2.
T1/2/RC = ln 2
T1/2 = ln 2
Student questions:
Exponential decrease
This worksheet has a good survey of a number of processes involving exponential decay:
radioactivity, capacitor discharge and more.
TAP 130-2: Exponential changes
2
TAP 130- 1: Electrical oscillations
Demonstration:
This demonstration shows electrical oscillations in which the capacitor helps to determine the
frequency. A comparison with a similar mechanical system is made. The demonstration includes
an inductor which may lie beyond your specification.
Apparatus
capacitor(s) 50 – 500 F
high inductance coil, choose coils from a demountable transformer kit if available
cell holder with four cells
oscilloscope (or datalogger with voltage sensor)
s.pdt. switch (if available)
leads
The cells are used to charge the capacitor which is then discharged through the inductor. With
the time-base set to a slow speed, decaying oscillations can be observed. Changing the
capacitance (or the inductance) will alter the frequency.
If you are able to record the output voltage, this gives a good example of exponentially damped
SHM.
The LC circuit can be compared to a mechanical system in which the capacitor is represented by
a spring and the inductor acts as a mass [your students will have to be told this].
3
A dynamics trolley is attached to a metre rule by two springs. A gentle motion of the stick can
maintain oscillations and at the resonant frequency the amplitude will be quite large. On
removing the driving force, the oscillations will die down as in the LC circuit.
External references
This activity is taken from Revised Nuffield Advanced Physics and is an adaptation of experiment
H26.
4
TAP 130- 2: Exponential changes
Many naturally occurring changes are exponential. That is, they follow a pattern in which equal
steps result in equal fractional changes. The following are just some of many possible examples.
Attenuation of electromagnetic radiation as it travels through a material (e.g. light in a glass
fibre). Equal increases in distance, x, result in equal fractional decreases in intensity, I.
Mathematically this can be expressed as
Capacitor discharge through a resistor. The discharge current, I, depends on the pd across
the capacitor
Radioactive decay. The number of nuclei decaying per unit time is proportional to the number of
unstable nuclei, N, present in a sample.
Population growth. The number of new offspring per unit time is proportional to the number of
organisms in a population.
Equations (1), (2), (3) and (4) all have the same form. They differ only in the symbols used and in
the sign of the constant on the right-hand side, which is negative for decay with distance or time,
and positive for growth. Each of equations (1), (2), (3) and (4) can be expressed in calculus
notation, allowing the intervals to become arbitrarily small. Integration then leads to another form
of equation for exponential change. For example, equation (1) becomes
5
If I0 is the intensity when x = 0, and Ix the intensity after a distance x, integrating between limits
gives
Questions
1.
Use calculus and equations (2), (3) and (4) to derive equations for the following:
(a)
charge, Q, on a discharging capacitor as a function of time;
(b)
number, N, of unstable nuclei as a function of time;
(c)
number, N, of organisms in a breeding population as a function of time.
In each of equations (1), (2), (3) and (4), the constant on the right-hand side is related to the time
or distance over which a quantity changes by a factor of e (e = 2.718). For example, from
equation (5) we have
It is often useful to consider the time or distance over which a quantity halves or doubles. Putting
Ix = I0/2 in equation (5) we get
taking reciprocals, cancelling and taking logs to base e gives
6
2.
Derive expressions for the following:
(a)
The time for the charge on a capacitor (i) to be reduced by a factor of e (ii) to halve.
(b)
The time for the number of unstable nuclei in a sample
(i)
to be reduced by a factor of e
(ii)
to halve.
(c)
The time for the number of organisms in a breeding population
(i)
to rise by a factor e
(ii)
to double.
7
Answers and worked solutions
External references
This activity is taken from Salters Horners Advanced Physics, A2, The Medium is the Message,
Section MDM, Additional sheet 2
8
Download