Connecting Cord with Wire
Specifications:
Cord Construction and Material
The body housing shall contain a female snap without resistor joined in series to the conductor with another female snap without
resistor. The ground end of the cord is moulded with single nylon material (strain relief / body housing)
Conductor : Diameter is 2.5 mm, with 7 tinsel wires
Insulation : Straight cord is insulated with Polyurethane material
Electrical Properties
The cord conductor shall have an end to end resistance not greater than 50 ohms
Bending Life Test
Exceeds 20,000 cycles of bending life test without any physical damage on the strain relief
Breakaway Force
1 to 5 lbs. of pull away force is required to disconnect the snap in a normal disconnect direction
Connection Integrity
The tensile strength of the end connections shall be not less than 66% of the tensile strength of the wire and in no case shall it be
less than 5 lbs
Colour
Three inches straight cord in yellow colour. Chips in PMS356 green colour
Hardware
All metal parts shall show no evidence of corrosion and rust after 24 hours submersion to salt solution. Preferably made from
stainless steel or brass alloy plated with nickel
Moulded Ends and Chips
Made of antistatic nylon material
Part Number Table
Description
Part Number
Connecting Cord with Wire, 115 mm
28502
Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of
it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces
all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use
made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted.
Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising)
is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2011.
www.element14.com
www.farnell.com
www.newark.com
15/11/11 V1.1